Simulation and analysis of tests of Belle II vertex detector sensors
Simulace a analýza testů senzorů pro vrcholový detektor Belle II
diplomová práce (OBHÁJENO)
Zobrazit/ otevřít
Trvalý odkaz
http://hdl.handle.net/20.500.11956/72591Identifikátory
SIS: 130200
Kolekce
- Kvalifikační práce [10691]
Autor
Vedoucí práce
Konzultant práce
Kodyš, Peter
Oponent práce
Drásal, Zbyněk
Fakulta / součást
Matematicko-fyzikální fakulta
Obor
Jaderná a subjaderná fyzika
Katedra / ústav / klinika
Ústav částicové a jaderné fyziky
Datum obhajoby
1. 9. 2014
Nakladatel
Univerzita Karlova, Matematicko-fyzikální fakultaJazyk
Angličtina
Známka
Výborně
Klíčová slova (česky)
Belle II, vrcholový detektor, alignment, fitování, testování detektorůKlíčová slova (anglicky)
Belle II, vertex detector, alignment, fitting, beam testPředložená diplomová práce popisuje vývoj a analýzu simulace, rekonstruckce a alignmentu pro testování sensorů vrcholového detektoru Belle II a proceduru pro alignment samotného vertexového detektoru. Prvním cílem práce bylo vytvoření a validace nástrojů pro analýzu testů sensorů přímo v prostředí společného softwarového rámce experiment Belle II. Druhým cílem byla příprava procedury pro alignment kompletního vertexového detektoru, která je nedílnou součástí procesu kalibrace. První část práce se věnuje experiment Belle II, vrcholovému detektoru, experimentálnímu testu jeho sensorů a popisu společného softwarového prostředí. Zvolená aligmentovací procedura, Millepede II, a fitování pomocí General Broken Lines jsou teroreticky objasněny. Druhá část práce pak shrnuje software, který byl pro práci vyvinut nebo použit a výsledky, které byly s jeho pomocí dosaženy, s důrazem na alignment.
This master thesis describes development and analysis of simulation, reconstruction and alignment for tests of Belle II vertex detector sensors as well as alignment procedure for the vertex detector itself. The first goal is to develop and test software tools which would allow analysis of sensor tests within common Belle II software framework. The second goal is to prepare the alignment chain for the vertex detector, being essential component of the detector calibration. First part of the thesis describes the Belle II experiment and its vertex detector, as well as the experimental beam test of the sensors and the common software framework. The theory behind the used alignment procedure utilizing Millepede II for alignment and General Broken Lines for track fitting is explained. Second part of the thesis then summarizes software tools developed or used and the results reached with these tools with emphasis on the alignment.