Hledat
Zobrazují se záznamy 21-30 z 30
Investigation of deformation mechanisms in textured magnesium alloy by advanced in-situ methods
Studium deformačních mechanismů v hořčíkové slitině s texturou pomocí pokročilých in-situ metod
Diplomová práce (OBHÁJENO)
Vedoucí práce: Minárik, Peter
Datum publikování: 2021
Datum obhajoby: 29. 06. 2021
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Název práce: Studium deformačních mechanism· v hořčíkové slitině s texturou pomocí pokročilých in-situ metod Autor: Bc. Jan Dittrich Katedra: Katedra fyziky materiál· Vedoucí diplomové práce: RNDr. Peter Minárik, PhD., ...
Title: Investigation of deformation mechanisms in textured magnesium alloy by advanced in-situ methods Author: Bc. Jan Dittrich Department: Department of Physics of Materials Supervisor: RNDr. Peter Minárik, PhD., Department ...
Title: Investigation of deformation mechanisms in textured magnesium alloy by advanced in-situ methods Author: Bc. Jan Dittrich Department: Department of Physics of Materials Supervisor: RNDr. Peter Minárik, PhD., Department ...
Vlastnosti tenkých vrstev studované pomocí in-situ TEM.
Properties of thin films studied by in-situ TEM
Diplomová práce (OBHÁJENO)
Vedoucí práce: Cieslar, Miroslav
Datum publikování: 2021
Datum obhajoby: 15. 09. 2021
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Mechanické vlastnosti široko aplikovateľných tenkých nanokryštalických filmov sú už nejakú dobu objektom záujmu pre ich rozdiely od vlastností typicky pozorovaných v objemových materiáloch so zrnami na mikrometrovej škále. ...
Mechanical properties of widely applicable thin nanocrystalline films have been a sub- ject of interest for some time due to deviation of their properties from the properties of bulk and micro sized grain materials. The ...
Mechanical properties of widely applicable thin nanocrystalline films have been a sub- ject of interest for some time due to deviation of their properties from the properties of bulk and micro sized grain materials. The ...
Microstructure and mechanical properties study of the finegrained magnesium alloys processed by severe plastic deformation
Studium mikrostruktury a mechanických vlastností jemnozrnných hořčíkových slitin připravených intenzivní plastickou deformací
Diplomová práce (OBHÁJENO)
Vedoucí práce: Stráská, Jitka
Datum publikování: 2021
Datum obhajoby: 29. 06. 2021
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Dvě hořčíkové slitiny (Mg-4Y-4Gd-2Ca a Mg-2Y-2Gd-1Ca) vyznačující se vysokou teplo- tou vznícení byly zpracovány extruzí. Slitina Mg-2Y-2Gd-1Ca byla navíc zpracována metodou ECAP pro dosažení ultrajemnozrnné mikrostruktury. ...
Two magnesium alloys (Mg-4Y-4Gd-2Ca and Mg-2Y-2Gd-1Ca) with high ignition tem- perature were successfully processed by extrusion. Mg-2Y-2Gd-1Ca alloy was addition- ally processed by equal channel angular pressing (ECAP) ...
Two magnesium alloys (Mg-4Y-4Gd-2Ca and Mg-2Y-2Gd-1Ca) with high ignition tem- perature were successfully processed by extrusion. Mg-2Y-2Gd-1Ca alloy was addition- ally processed by equal channel angular pressing (ECAP) ...
Výzkum deformačních mechanismů pokročilých lehkých slitin
Investigation of deformation mechanisms of advanced light-weight alloys
Diplomová práce (OBHÁJENO)
Vedoucí práce: Mathis, Kristián
Datum publikování: 2016
Datum obhajoby: 12. 09. 2016
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Cílem této diplomové práce je prozkoumat mechanické a tlumící vlastnosti slitin AZ91 s přidáním různého množství legujícího prvku bor a dvou experimentálních slitin na bázi čistého hořčíku. Dalším úkolem je určit vliv ...
The objective of this thesis is to investigate the mechanical and damping properties in AZ91 alloys with different boron concentrations and in two experimental alloys based on commercial pure magnesium. Further aim is to ...
The objective of this thesis is to investigate the mechanical and damping properties in AZ91 alloys with different boron concentrations and in two experimental alloys based on commercial pure magnesium. Further aim is to ...
Effect of microstructure on mechanisms of plastic deformation in fine-grained magnesium alloys
Vliv mikrostruktury na mechanismy plastické deformace v jemnozrnných hořčíkových slitinách
Diplomová práce (OBHÁJENO)
Vedoucí práce: Král, Robert
Datum publikování: 2010
Datum obhajoby: 17. 05. 2010
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Táto práca sa zaoberá štúdiom vplyvu zjemnenia zrna na mechanické vlastnosti a koroziodolnosť horčíkových zliatin potenciálnych pre použitie v medicíne - AE21 a AE42. Mechanické vlastnosti sa menili s pretláčaním cez ECAP ...
In this work were studied effects of the grain refinement on the mechanical properties and the corrosion resistance of magnesium alloys potential for medical applications - AE21 and AE42. Mechanical properties changed after ...
In this work were studied effects of the grain refinement on the mechanical properties and the corrosion resistance of magnesium alloys potential for medical applications - AE21 and AE42. Mechanical properties changed after ...
Studium nestabilní plastické deformace metodou akustické emise
Studium nestabilní plastické deformace metodou akustické emise
Diplomová práce (OBHÁJENO)
Vedoucí práce: Dobroň, Patrik
Datum publikování: 2014
Datum obhajoby: 27. 05. 2014
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Byl studován výskyt plastických nestabilit v protlačované slitině AlSi1MgMn (6082) a válcované slitině AlMg4.5Mn0.4 (5182) jako důsledek změny rychlosti deformace a tepelného zpracování. Vzorky byly podrobeny jednoosé ...
The influence of the strain rate and heat treatment on the occurrence of plastic instabilities in extruded AlSi1MgMn (6082) and cold rolled AlMg4.5Mn0.4 (5182) alloys was studied. The samples were uniaxially loaded at ...
The influence of the strain rate and heat treatment on the occurrence of plastic instabilities in extruded AlSi1MgMn (6082) and cold rolled AlMg4.5Mn0.4 (5182) alloys was studied. The samples were uniaxially loaded at ...
Studium deformačních procesů perspektivních kompozitů na bázi hořčíku
Study of deformation processes of perspective magnesium-based composites
Studium deformačních procesů perspektivních kompozitů na bázi hořčíku
Diplomová práce (OBHÁJENO)
Vedoucí práce: Mathis, Kristián
Datum publikování: 2013
Datum obhajoby: 14. 05. 2013
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Cílem práce je vysvětlit deformační mechanizmy probíhající v kompozitech na bázi hořčíku a vliv morfologie zpevňující fáze na mechanické vlastnosti. Mikrostruktura byla studována optickým a elektronovým mikroskopem (SEM). ...
The goal of the present work is investigation of deformation mechanisms in magnesium-based metal matrix composites and examination of the influence of morphology of strengthening phase on the mechanical properties. The ...
The goal of the present work is investigation of deformation mechanisms in magnesium-based metal matrix composites and examination of the influence of morphology of strengthening phase on the mechanical properties. The ...
Mikrostruktura nerovnovážných tuhých roztoků na bázi Al-Mn
Microstructure of non-equiblirium Al-Mn based solid solutions
Diplomová práce (OBHÁJENO)
Vedoucí práce: Cieslar, Miroslav
Datum publikování: 2010
Datum obhajoby: 17. 05. 2010
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Tepelné výměníky v automobilovém průmyslu jsou často vyráběny z hliníkové slitiny AW 3003. Současná snaha o redukci hmotnosti automobilů vede k potřebě snížit tloušťku fólií, ze kterých se výměníky vyrábí. Aby se vyhovělo ...
Heat exchangers in automotive industry are often manufactured from aluminum-based alloy AW 3003. In recent time, the aim to reduce the weight of the cars leads to thickening of the foils, which are used for manufacturing ...
Heat exchangers in automotive industry are often manufactured from aluminum-based alloy AW 3003. In recent time, the aim to reduce the weight of the cars leads to thickening of the foils, which are used for manufacturing ...
Studium dynamiky deformačních procesů ve slitinách Mg-RE pomocí in-situ experimentálních metod
Investigation of the dynamics of the deformation processes in Mg-RE alloys using in-situ experimental methods
Studium dynamiky deformačních procesů ve slitinách Mg-RE pomocí in-situ experimentálních metod
Diplomová práce (OBHÁJENO)
Vedoucí práce: Mathis, Kristián
Datum publikování: 2021
Datum obhajoby: 15. 09. 2021
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Předložená práce se zabývá studiem dynamiky deformačních procesů binárních slitin Mg-Gd pomocí in-situ experimentálních metod v závislosti na koncentraci Gd. Zkoumané lité slitiny jsou charakterizované náhodnou texturou. ...
In this present work, the dynamics of deformation mechanisms activated in binary magnesium-gadolinium alloys with respect to amount of Gd were investigated with in-situ experimental methods. Cast alloys are characterized ...
In this present work, the dynamics of deformation mechanisms activated in binary magnesium-gadolinium alloys with respect to amount of Gd were investigated with in-situ experimental methods. Cast alloys are characterized ...
Strukturní parametry martenzitu v Ti slitinách, ovlivněné přítomností atomů kyslíku
Structure parameters of martensite in Ti alloys modified by presence of oxygen atoms
Diplomová práce (OBHÁJENO)
Vedoucí práce: Preisler, Dalibor
Datum publikování: 2024
Datum obhajoby: 08. 02. 2024
Fakulta / součást: Matematicko-fyzikální fakulta / Faculty of Mathematics and Physics
Abstrakt: Structure parameters of martensite in Ti alloys modified by presence of oxygen atoms This study discusses the influence of beta-stabilizing elements and oxygen on the martensitic structure in metastable β titanium alloys. ...
Štruktúrne parametre martenzitu v titánových zliatinách modifikované prítomnosťou atómov kyslíka Táto štúdia pojednáva o vplyve β-stabilizačných prvkov a kyslíka na martenzitickú štruktúru v metastabilných β zliatinách ...
Štruktúrne parametre martenzitu v titánových zliatinách modifikované prítomnosťou atómov kyslíka Táto štúdia pojednáva o vplyve β-stabilizačných prvkov a kyslíka na martenzitickú štruktúru v metastabilných β zliatinách ...