Transmission Electron Microscopy of Al-Mg Aluminium Alloys with Addition of Sc and Zr
Transmisní elektronová mikroskopie hliníkových slitin Al-Mg s přídavkem Sc a Zr
bachelor thesis (DEFENDED)

View/ Open
Permanent link
http://hdl.handle.net/20.500.11956/108238Collections
- Kvalifikační práce [9109]
Author
Advisor
Referee
Málek, Přemysl
Faculty / Institute
Faculty of Mathematics and Physics
Discipline
General Physics
Department
Department of Physics of Materials
Date of defense
25. 6. 2019
Publisher
Univerzita Karlova, Matematicko-fyzikální fakultaLanguage
English
Grade
Excellent
Keywords (Czech)
Transmisní elektronová mikroskopie, skenovací elektronová mikroskopie, hliníkové slitiny, mikrostruktura
Keywords (English)
Transmission electron microscopy, scanning electron microscopy, aluminium alloys, microstructure
Abstrakt. Mikrostruktura hliníkové slitiny Al-3.2Mg-0.19Sc-0.14Zr (hm.%) připravené metodou plynulého odlévání mezi válce byla studována pomocí světelné a elektronové mikroskopie. Materiál byl podroben isotermickému žíhání 300 řC / 8 h a/nebo deformován metodou protlačování pravoúhlým kanálem za účelem zlepšení mechanických vlastností. Žíhání vedlo k precipitaci jemné dis- perze metastabilní fáze Al3(Sc,Zr) a zvýšení mikrotvrdosti o 20 HV. Protlačování pravoúhlým kanálem výrazně snížilo velikost zrn a způsobilo nárůst mikrotvr- dosti o 30 HV. Kombinace obou metod - žíhání a deformace v různém pořadí - nepřineslo další zpevnění materiálu. Nicméně, při vystavení studované slitiny isochronnímu žíhání do 600 řC bylo prokázáno, že Al3(Sc,Zr) precipitáty, vzniklé při předchozím žíhání 300 řC / 8 h, značně stabilizují mikrostrukturu a omezují růst zrn po rekrystalizaci. 1
Abstract. The microstructure and its evolution during isochronal annealing of a twin roll cast Al-3.2Mg-0.19Sc-0.14Zr (wt.%) alloy was investigated by light optical microscopy and electron microscopy. Two procedures - equal channel an- gular pressing and annealing at 300 řC for 8 h were applied to enhance mechanical properties of the alloy. The annealing led to the precipitation of a fine dispersion of Al3(Sc,Zr) particles providing an increase of ∼20 HV in the Vickers microhard- ness. Equal channel angular pressing refined significantly the microstructure and raised the microhardness by about 30 HV. Applying of the 300 řC / 8 h both before and after equal channel angular pressing did not induce further strength- ening. However, the precipitation of the Al3(Sc,Zr) phase had a stabilizing effect when the material was exposed to the subsequent isochronal annealing. 1