Tests of Semiconductor Detectors in Prague Laboratory
Testování polovodičových detektorů v pražské laboratoři
bakalářská práce (OBHÁJENO)
Zobrazit/ otevřít
Trvalý odkaz
http://hdl.handle.net/20.500.11956/108154Identifikátory
SIS: 169496
Kolekce
- Kvalifikační práce [10932]
Autor
Vedoucí práce
Oponent práce
Carli, Ina
Fakulta / součást
Matematicko-fyzikální fakulta
Obor
Obecná fyzika
Katedra / ústav / klinika
Ústav částicové a jaderné fyziky
Datum obhajoby
25. 6. 2019
Nakladatel
Univerzita Karlova, Matematicko-fyzikální fakultaJazyk
Angličtina
Známka
Velmi dobře
Klíčová slova (česky)
Testy polovodičových detektorů, křemíkový detektor, elektronika, ROOT, GPIB, RS-232Klíčová slova (anglicky)
Tests of semiconductor detectors, silicon detector, electronics, ROOT, GPIB, RS-232Tato bakalářská práce je zaměřená na využití křemíkových po- lovodičových detektorů v experimentu ATLAS a na automatizaci ochlazo- vacích a ohřívacích procesů po dobu testování detektorů při zvolené tep- lotě. Testy jsou vykonané v prostředí mrazicího boxu a je nutné, aby po dobu celého testu zůstalo místo, kde je detektor umístěný, suché. Toto je zabezpečené monitorováním teploty a relativní vlhkosti vzduchu daného pro- středí pomocí přístroje Interlock se senzory a automatickým výpočtem tep- loty rosného bodu bez využití dusíku, který se běžně využívá v podobných testech. Ochlazovací i ohřívací procesy jsou ve fázi přípravy na úplnou au- tomatizaci, co bude minimalizovat manuální manipulaci, která je nutná na obsluhu testů. Tím bude zajištěný plynulý a bezpečný průběh daných testů. 1
This thesis is focused on the usage of silicon semiconductor detectors in ATLAS experiment and automation of safe cooling and heating processes needed during the tests performed on detectors at a given tem- perature. The tests take place in the freezer environment with the place of interest where the detector is to be placed required to stay dry throughout the entire test. This is secured by monitoring the temperature and rela- tive humidity of the environment using Interlock device with sensors and by automatic calculation of the dew point temperature without any supply of nitrogen commonly used in other set ups of the tests. Both cooling and heating processes are being prepared to be fully automatized, reducing the amount of manual handling required to minimum which helps to maintain the conditions and safe run of the test. 1