Analýza nanočásticových systémů atomovou spektrometrií
Analysis of nanopartical systems by atomic spectrometry
diploma thesis (DEFENDED)
View/ Open
Permanent link
http://hdl.handle.net/20.500.11956/98112Identifiers
Study Information System: 174630
Collections
- Kvalifikační práce [19614]
Author
Advisor
Consultant
Kubíček, Vojtěch
Referee
Nováková, Eliška
Faculty / Institute
Faculty of Science
Discipline
Clinical and Toxicological Analysis
Department
Department of Analytical Chemistry
Date of defense
30. 5. 2018
Publisher
Univerzita Karlova, Přírodovědecká fakultaLanguage
Czech
Grade
Very good
Keywords (Czech)
Atomová absorpční spektrometrie, plamenová atomizace, elektrotermická atomizace, optimalizace, stanovení, titan, fosfor, nanočásticové systémyKeywords (English)
Atomic absorption spectrometry, flame atomization, electrothermal atomization, optimalization, determination, titanium, phosphorus, nanopartical systemsCZ Tato diplomová práce se zabývá optimalizací metod stanovení koncentrací titanu a fosforu pro jejich využití při analýze koloidních roztoků nanočástic TiO2 modifikovaných bisfosfonáty. Pro tyto analýzy bylo využito atomové absorpční spektrometrie s plamenovou a elektrotermickou atomizací. Současně byly porovnány charakteristiky stanovení obou analytů na dvou odlišných spektrometrech. Technikou F-AAS na spektrometru GBC 933 AA bylo pro titan dosaženo detekčního limitu 5,2 mg l-1 , a pro fosfor bylo dosaženo detekčního limitu 163 mg l-1 . Na spektrometru ContrAA 700 bylo technikou F-AAS dosaženo téměř pětkrát nižšího detekčního limitu 1,1 mg l-1 pro stanovení titanu. Pro stanovení fosforu na tomto spektrometru bylo dosaženo podobné hodnoty 151 mg l-1 , jako na spektrometru GBC 933 AA. Při stanovení fosforu technikou ET-AAS na spektrometru ContrAA 700 bylo dosaženo detekčního limitu 1,23 mg l-1 , což je oproti plamenové technice výrazný rozdíl. Bylo prokázáno, že optimalizované metody vyhovují danému záměru, což bylo potvrzeno při analýze reálných vzorků obsahujících titan a fosfor v koloidním roztoku nanočástic TiO2 modifikovaných bisfosfonáty.
EN The present diploma thesis is focused on optimization methods of titanium and phosphorus concentration for their use in the colloidal solution of TiO2 nanoparticles modified by bisphosphonates. For these analyses was used atomic absorption spectrometry with flame and electrothermal atomization. The characteristics of the two analytes were compared to two different spectrometers. Using the F-AAS technique on the GBC 933 AA spectrometer has been achieved a detection limit of 5,2 mg l-1 for titanium and a detection limit of 163 mg l-1 for the phosphorus. Using the ContrAA 700 spectrometer, F-AAS has been achieved an almost five times lower detection limit of 1,1 mg l-1 for titanium determination. For determination of phosphorus using this spectrometer, was obtained a similar value of 151 mg l-1 , as using the GBC 933 AA spectrometer. The determination of phosphorus by the ET-AAS technique using the ContrAA 700 spectrometer resulted in a detection limit of 1,23 mg l-1 , which is a significant difference compared to the flame system. It has been proved that optimized methods are consistent with the intention, which was confirmed by the analysis of real titanium and phosphorus samples in the colloidal solution of TiO2 nanoparticles modified bisphosphonates.