Depozice ultratenkých vrstev na polymerní substráty
Deposition of ultrathin films on polymers
bakalářská práce (OBHÁJENO)
Zobrazit/ otevřít
Trvalý odkaz
http://hdl.handle.net/20.500.11956/86378Identifikátory
SIS: 182385
Kolekce
- Kvalifikační práce [11211]
Autor
Vedoucí práce
Oponent práce
Kousal, Jaroslav
Fakulta / součást
Matematicko-fyzikální fakulta
Obor
Obecná fyzika
Katedra / ústav / klinika
Katedra makromolekulární fyziky
Datum obhajoby
21. 6. 2017
Nakladatel
Univerzita Karlova, Matematicko-fyzikální fakultaJazyk
Čeština
Známka
Výborně
Klíčová slova (česky)
magnetronové naprašování, tenké vrstvy, polymerní substrátyKlíčová slova (anglicky)
magnetron sputtering, thin film, polymer substrateTenké kovové vrstvy deponované na polymerní substráty mají zásadní význam pro tvorbu vodivých struktur na površích polymerů. V případě nespojitých vrstev stříbra či mědi se zde navíc objevuje takzvaná anomální absorpce ve viditelné části spektra. Tohoto jevu lze využít pro tvorbu různých senzorů, např. založených na povrchově zesílené Ramanově spektroskopii. V této práci byla konkrétně zkoumána příprava ultratenkých nespojitých vrstev Ag a Cu na polymerní fólie PEEK a PET a jako reference sloužilo sklo a leštěný Si. Pro depozici bylo zvoleno magnetronové naprašování za velmi nízkého tlaku a byl zkoumán vliv tlaku na způsob růstu těchto vrstev. Bylo zjištěno, že za tlaku 0,2 Pa rostou měděné vrstvy na obou polymerech téměř hladké, zatímco za 1,2 Pa se již objevuje ostrůvková struktura. V případě naprašování Ag se ostrůvková struktura vrstvy projevila i za tlaku 0,2 Pa a byly pozorovány i rozdíly v růstu Ag vrstvy v závislosti na substrátu.
Thin metal films deposited on the polymer substrates are of fundamental importance for the formation of conductive structures on the surfaces of the polymers. In the case of discontinuous layers of silver or copper, so-called anomalous absorption occurs in the visible range of the spectrum. This phenomenon can be used to create different sensors, eg. based on surface enhanced Raman spectroscopy. In this work, the deposition of discontinuous Ag and Cu layers on PEEK and PET polymer foils and glass and polished silicon was used studied. The magnetron sputtering was chosen for deposition at very low pressure and the effect of pressure on the growth of these films was investigated. It was found that at a pressure of 0.2 Pa the copper layers on the two polymers grew almost smooth, while the island structure appeared at a pressure 1.2 Pa. In the case of Ag deposition, the island structure of the layer appeared already at a pressure of 0.2 Pa, and differences in the growth of the Ag films in dependence of the the substrate were observed.