Stanovení antimonu metodou elektrochemického generování
Antimony determination by electrochemical hydride generation
bakalářská práce (OBHÁJENO)
Zobrazit/ otevřít
Trvalý odkaz
http://hdl.handle.net/20.500.11956/51024Identifikátory
SIS: 78425
Kolekce
- Kvalifikační práce [20052]
Autor
Vedoucí práce
Oponent práce
Rychlovský, Petr
Fakulta / součást
Přírodovědecká fakulta
Obor
Klinická a toxikologická analýza
Katedra / ústav / klinika
Katedra analytické chemie
Datum obhajoby
7. 9. 2011
Nakladatel
Univerzita Karlova, Přírodovědecká fakultaJazyk
Čeština
Známka
Výborně
Klíčová slova (česky)
Atomová absorpční spektrometrie, elektrochemické generování těkavých sloučenin, křemenný atomizátor, elektrolytická tenkovrstvá a tubulární elektrolytická cela, antimonKlíčová slova (anglicky)
Atomic absorption spectrometry, electrochemical generation of volatile compounds, quartz tube atomizer, thin-layer and tubular electrolytic cell, antimonyPředkládaná bakalářská práce je věnována studiu možností elektrochemického generování těkavého hydridu antimonu při využití nově zkonstruovaných typů elektrolytických cel. Byly prostudovány vlastnosti tenkovrstvé a tubulární elektrolytické cely a získané charakteristiky stanovení antimonu byly následně porovnány s metodou chemického generování. Nejprve byly pro obě nově zkonstruované elektrolytické cely optimalizovány pracovní parametry, které výrazně ovlivňují velikost absorpčního signálu získaného při generování těkavého hydridu antimonu. Za optimálních pracovních podmínek bylo provedeno kalibrační měření a zjištěny další charakteristiky stanovení antimonu. S tenkovrstvou celou byla dosažena citlivost 3,40·10-3 l·μg-1 , s tubulární celou citlivost 6,10·10-3 l·μg-1 a využitím chemického generování hodnota dosažené citlivosti činila 2,10·10-3 l·μg-1 . Dále byl studován vliv zavádění kyslíku do různých částí aparatury, což mělo za následek vznik charakteristického a dobře reprodukovatelného píku. Klíčová slova Atomová absorpční spektrometrie, elektrochemické generování těkavých sloučenin, křemenný atomizátor, elektrolytická tenkovrstvá a tubulární elektrolytická cela, antimon
The aim of the presented bachelor thesis is to study the possibilities of the electrochemical hydride generation of volatile antimony hydride, using two newly constructed electrolytic cells. In this work, the properties of the cells were studied and consequently the basic characteristics of antimony determination obtained using new cells were compared with the chemical hydride generation method. At the beginning of the work, the relevant working parameters of both electrolytic cells were optimized. Under the optimal working conditions the calibration and other characteristics were carried out for antimony determination. Using the electrochemical hydride generation with thin-layer electrolytic cell and tubular cell and chemical hydride generation the sensitivity 3.40·10-3 l·μg-1 , 6.10·10-3 l·μg-1 and 2.10·10-3 l·μg-1 respectively were obtained. Finally, the influence of oxygen introduction in the different part of experimental setup was studied. This oxygen addition caused the characteristic and well-reproducible absorption peak. Key words Atomic absorption spectrometry, electrochemical generation of volatile compounds, quartz tube atomizer, thin-layer and tubular electrolytic cell, antimony