Analýza statické pevnosti samosvorných uzlů používaných ve vojenském lezení
Static strength analysis of friction knots used in military climbing
bachelor thesis (DEFENDED)
View/ Open
Permanent link
http://hdl.handle.net/20.500.11956/120511Identifiers
Study Information System: 221678
Collections
- Kvalifikační práce [8435]
Author
Advisor
Referee
Baláš, Jiří
Faculty / Institute
Faculty of Physical Education and Sport
Discipline
Military Physical Education
Department
Information is unavailable
Date of defense
4. 9. 2020
Publisher
Univerzita Karlova, Fakulta tělesné výchovy a sportuLanguage
Czech
Grade
Very good
Keywords (Czech)
vojenské lezení, samosvorný uzel, pevnost uzlu, prokluz, bod selhání, nominální pevnostKeywords (English)
military climbing, friction knot, knot strength, slip, point of failure, nominal strengthNázev: Analýza statické pevnosti samosvorných uzlů používaných ve vojenském lezení. Cíl: Zjištění pevnosti vybraných uzlů při statickém zatížení na nízko průtažných lanech. Metody: Tato bakalářská práce popisuje laboratorní experiment, díky kterému byl zjištěn vliv samosvorných uzlů na pevnost pomocné Reep šňůry navázané na nízko-průtažné lano při statickém zatížení. Pro analýzu byla vybrána 6mm Reep šňůra a 10,5mm lano a samosvorné uzly používané v technikách vojenského lezení. Testování probíhalo na vertikálním zkušebním zařízení. Každý z vybraných uzlů byl podroben deseti pokusům. Jednotlivé uzly byly mezi sebou porovnány z několika hledisek, a to prvního prokluzu, délky prokluzu, maximální pevnosti, poklesu nominální pevnosti a bodu selhání. Výsledky: Nejvyšší průměrné hodnoty prvního prokluzu a maximální pevnosti dosahoval Vánočkový prusík. Nejnižší hodnota délky prokluzu byla naměřena u samosvorného uzlu Blake. U Blakeova uzlu v porovnání s ostatními z vybraných uzlů byl zjištěn nejnižší pokles nominální pevnosti a to o 14 %, naopak nejvyšší pokles nominální pevnosti je u Vánočkového prusíku. Pomocná Reep šňůra selhala v 81 % všech pokusů. Klíčová slova: vojenské lezení, samosvorný uzel, pevnost uzlu, prokluz, bod selhání, nominální pevnost
Title: Analysis of static strength of friction knots used in military climbing. Objectives: Strength determination of selected knots on static ropes under static load. Methods: This bachelor thesis shows a laboratory experiment, where the influence of friction knots on the strength of the Reep cord tied to a static rope under static load was determined. For the purposes, a 6mm Reep cord and 10.5mm rope and friction knots used in military climbing techniques were selected. The experiment was run on a vertical test rig. Each of the selected knots was tested 10 times. Every knot was compared among the others in the first slip, slip length, maximum strength, nominal strength drop and the point of failure. Results: The highest average values of the first slip and the maximum strength were achieved by the Twist prusik. The lowest value of the slip length was measured at the Blake friction knot. Compared to other of the selected knots, the lowest decrease in nominal strength by 14 % was found on the Blake knot, while the highest decrease in nominal strength is found in the Twist prusik. The Reep Cord failed in 81 % of all attempts. Keywords: military climbing, friction knot, knot strength, slip, point of failure, nominal strength